V-V-Mirror-View-3 TFT LCD Color 7.0" Mirror Monitor with License

$356.88

357 reward points

V-V-Mirror-View-3 TFT LCD Color 7.0" Mirror Monitor with License Plate Frame Camera

7.0" TFT LCD Color Mirror Monitor with License Plate Frame Camera

Detailed Description

V-V-MIRROR-VIEW-3

Our New V-V-Mirror-View-3 camera system includes a REAR VIEW MIRROR MONITOR and a color camera. The 7.0” TFT LCD Color monitor is built into the rear view mirror. Simply clip the Mirror Monitor over your existing rear view mirror. The monitor has two Video inputs for a second camera or DVD player. The monitor will automatically turn one when the vehicle is put in reverse. Use the remote control to switch to the second camera or DVD player. The License Plate Frame Camera is a CCD Color, waterproof camera with a wide 130 degree angle lens and 20 foot cable. The License Plate Frame camera is very discreet, no one will even know it is a camera. This camera is available in Full Frame or Top Bar Only type. Also available in Chrome or Black Matte Finish

MONITOR FEATURES:
7.0” TFT LCD Color Display built into mirror
Clips over existing rear view mirror
Turns on automatically when vehicle is in reverse
DC 12 Volt Power
Operating Temp: -20C to 60C
Dual Video Input
Dimensions: Appx. 10” L x 4” H x 1” Deep
Remote control operation

CAMERA SPECIFICATIONS:

◊ Dimensions of License Plate Full Frame Camera:
12.5" L x 7" H x 2.75" Deep
◊ Dimensions of License Plate Top Bar Camera:
12.5" L x 1.5" H x 2.75" Deep
◊ Light sensitive 1/3" CCD color image device
◊ Wide angle lens with 130 degree horizontal and 90 vertical field of view
◊ High resolution (320 TV lines or 250,000 pixels)
◊ Weather resistant and waterproof housing
◊ Powerful 1.0 LUX illumination rating
◊ DC 12 volt power supply
◊ Minimal 180mA power consumption
◊ Operating temperature: -25? to 85? Celsius (-13? to 185? F)
◊ Light Weight: 2.5 ounces
◊ Mirror Image Picture
◊ Finish: Chrome or Matte Black
◊ One Year Warranty

Installation
In order to install either License Plate Frame camera, you must make two small cuts at the top of the License Plate and then bend the plate back to form a small notch which will accommodate the camera lens. Check for your state regulations and laws before ordering

Add to Cart: